CANNY logic forum — CANNY 5.3 pico / MD1A

Sending ADC Value to CAN

null@example.com (lee2026) — Wed, 30 Jul 2025 12:57:07 +0000

Hi I am trying to send an ADC value to CAN but I am having trouble even connecting to the bus.

I have the program "FuelPumpPrime+Scramble2.3" working on a different bus at 100k bit/s.

However when I try to use the same method to connect to a 500k bit/s bus, I don't seem to get any data. I have uploaded the ccm firmware to the device and I can connect and read the bus at 500k bit/s. But when I put a test value of 0 for Y under Engine_Run_Only_Signal (Oil_Press+Engine_Run_Signal+CAN_Broadcast), the output does not trigger. I don't seem to be receiving can data.

I'm also not sure if the pic5.3 is transmitting any data.

Output 8 also doesn't seem to be doing what it should. With no input from ADC, the output should be grounded but it seems to float.

I have confirmed CAN terminations and do not need any; there is 60ohms resistance on the bus wiring and the point I am tapping is where I had removed an auto trans control modules so I know it was not EOL.

5.3 MD1A start parameters

null@example.com (StarG8) — Mon, 30 Jun 2025 21:44:25 +0000

Hello! Can someone guide me how to get started with setting up the MD1A to get 5v from channel 8? I am using 12v input voltage and also intend to read the voltages 0-5v on channels 9 and 10, which I have jumpered to the appropriate adc contacts on the unit. Any assistance with the registers is very appreciated!

3d Model

null@example.com (lelsteph) — Sun, 07 Aug 2022 15:56:16 +0000

Hello

Do you have a 3D model of the PICO 5.3 Module?

Stephane.

Type and Reference of the connector

null@example.com (lelsteph) — Sun, 12 Jun 2022 10:51:11 +0000

Hello

Can you please confirm the type of connector used?

Is this PHDR-08VS for the cable?

Thanks

How to create SFX without a diagram and even a firmware?

null@example.com (lelsteph) — Tue, 07 Jun 2022 15:48:18 +0000

Hello

I need to be able to create an SFX to allow users to update the User Parameters BUT I do not want to provide the diagram as it could be stolen to replicate the modules. The firmware is not even needed in this use case.

Thank for any help!

Canny Data Transfer

null@example.com (kammykhan) — Sat, 04 Dec 2021 12:43:45 +0000

My old canny module messed up and i got a replacement canny, but how do you transfer the data from the old one to the new one.

Cannylab doesn't have reading data feature or am i missing something.

thanks

Canny 5.3 pico - Termination resistor

null@example.com (lelsteph) — Sat, 04 Jan 2020 13:11:26 +0000

Hello

Where is the location of the termination resistor?

Stephane.