CANNY logic forum — Replacement for the Canny5.2

Re: Replacement for the Canny5.2

null@example.com (Konstantin, CANNY logic) — Sat, 01 Dec 2018 20:26:31 +0000

We considered this option. We will put 120R on the board with soldering switch.

Re: Replacement for the Canny5.2

null@example.com (cubic_nz) — Fri, 30 Nov 2018 20:31:13 +0000

Is it possible to build the 120 Ohm resistor into the Canny7.2 as well? For now I have been soldering a resistor across the wires going into the Canny, but I think it would be nicer if it was built into the board with some sort of hardware switch. Is this something you have looked at?

Re: Replacement for the Canny5.2

null@example.com (Konstantin, CANNY logic) — Wed, 28 Nov 2018 10:02:56 +0000

8 x full featured CANNY7-like IOs + 1ADC in CANNY7 form factor

Re: Replacement for the Canny5.2

null@example.com (cubic_nz) — Wed, 28 Nov 2018 09:32:12 +0000

That’s really good news. Will it have any more I/O? Will it be the same form factor as the 5.2?

Re: Replacement for the Canny5.2

null@example.com (Konstantin, CANNY logic) — Wed, 28 Nov 2018 06:21:34 +0000

We have finished designing the Canny 7.2 duo and currently finishing the development of firmware. It will be from x2 to x4 faster than Canny 5.2 duo and have other improvements. We plan to release an experimental batch of Canny 7.2 duo early next year.

Replacement for the Canny5.2

null@example.com (cubic_nz) — Tue, 27 Nov 2018 11:40:16 +0000

Are you able to give any update on the replacement for the 5.2? I have found the filtering function very useful and hope this will continue to be available in the Canny product line.