CANNY logic forum — Error in CAN Gateway driver operation chart?

Re: Error in CAN Gateway driver operation chart?

null@example.com (Konstantin, CANNY logic) — Sat, 29 Dec 2018 21:29:08 +0000

Sorry for delay. Exactly, the logging mode and excluding mode in the gateway are independent. Moreover, if the CAN GW driver is active and its logging mode is on, every incoming CAN message that has reached the CAN GW driver will be loaded into the CAN RX registers, regardless of any other CAN GW configuration parameters. You are right, the diagram in not precise enough for now. We will fix it soon. Thank you for your highly valuable comments!

Re: Error in CAN Gateway driver operation chart?

null@example.com (cubic_nz) — Mon, 24 Dec 2018 01:09:07 +0000

Sorry, one more thing with the diagram, should the lower part look like this? As I understand it, logging mode and excluding mode in the gateway are independent.

I find I get confused with all the gateway options, so having this diagram is really helpful!

Re: Error in CAN Gateway driver operation chart?

null@example.com (Konstantin, CANNY logic) — Sun, 23 Dec 2018 10:20:10 +0000

Thank you! Now fixed.

Also, is the 5.2 only able to light one colour LED at a time?

Yes, as in the CANNY 7, you can light only one LED color at a time. Green has priority.

Error in CAN Gateway driver operation chart?

null@example.com (cubic_nz) — Fri, 21 Dec 2018 22:30:11 +0000

Looking at the CAN gateway driver operation chart, I think there may be an error in the step for the Acceptance filters. Should the test "Is the Acceptance Filters enabled for CAN0?" be "Is the Acceptance Filters DISABLED for CAN0?"?

Also, is the 5.2 only able to light one colour LED at a time?