CANNY logic forum — Hi all

Re: Hi all

2020-01-25T09:12:50Z

In general, you can use several CAN devices in the single CAN network.

Re: Hi all

2020-01-24T18:53:28Z

Hi can I use 2x Canny 7 in the same vehicle as I need 18 CAN output
Thanks.

Re: Hi all

2020-01-24T15:17:29Z

So CANNY 7.2 duo have 9 GPIOs 12V(24V)/GND + 1 ADC + a couple of CAN interfaces.
I think it can take options 1+2+3 in general case.

Re: Hi all

2020-01-24T15:03:26Z

Hi I’m looking for options 2 and 3.

Thanks.

Re: Hi all

2020-01-24T11:37:29Z

I'm not sure I understand you correctly.

1. Do you need the tool for explore CAN-bus of your car using PC like this: https://www.youtube.com/watch?v=Dtc4XX374u4 ?
2. Or you need the stand-alone device, for putting in your car, which will accept +12/GND discreet signal, like switches and bulbs, convert is by some rules to CAN-messages and then send it to your dash cluster?
3. Or you need the stand-alone device, for putting in your car, which will receive CAN from BSI, convert by some rules and then send it to another CAN for your dash cluster?

Or you need 1+2 (CANNY 7) ?
Or you need 1+3 (CANNY 7.2 duo) ?

Hi all

2020-01-24T00:18:42Z

Hi all I’m looking for some advice. I’m building a Replica car and I need to send CAN to my dash cluster like indicators warning lights ect.
And I’m looking for a unit to read existing can signals data coming from the BSI
Can you advise me if your units will help.

Thanks.