CANNY logic forum — Canny 7 Demo kit

Re: Canny 7 Demo kit

null@example.com (Merlinxav) — Fri, 10 Apr 2020 16:05:23 +0000

Good morning, sir,
Thank you for your answer, everything works.
I'll see you soon.

Re: Canny 7 Demo kit

null@example.com (Konstantin, CANNY logic) — Wed, 25 Mar 2020 16:12:11 +0000

You need to prepare Demo Board to work first. Please see https://wiki.cannylogic.com/index.php?t … 7_Demo_Kit
Upload the firmware and your diagram to controller.
Turn the main controller power by setting 3-pos switch on demo board in position Power (see label 12 on picture below)
Select the push button polarity by setting 3-pos switch on demo board in properly position (see label 13 on picture belo)

Then if you press any push button, voltage with selected polarity will applied to appropriate controller's channel.

With attached diagram:
Set push button polarity to +12V then press and hold CH0 button for 200 ms or longer and release for 200 ms or longer for switch CH1 output on and off. The controller on-board LED will indicate debounced CH0 state.

Canny 7 Demo kit

null@example.com (Merlinxav) — Wed, 25 Mar 2020 10:16:12 +0000

Good morning, everyone,
I bought a demo kit to learn how to use the cannylab.
I can't get the switches to work in input mode. After several tries I can't understand how to program this function.
I would like for example to use switch 0 in input mode to drive the leds in output mode of channel 1.
Can you help me ?
I consulted the wiki but I haven't found the solution.
Waiting for your answer.
Best regards.