<![CDATA[CANNY logic forum — CAN Mode, change speed on the fly]]> 2022-01-25T13:00:17Z PunBB https://forum.cannylogic.com/viewtopic.php?id=51 <![CDATA[Re: CAN Mode, change speed on the fly]]> You can do it too. But unlike CAN it is possible to get false-positive result then you will try to "scan" different LIN speeds this way.

]]> https://forum.cannylogic.com/profile.php?id=2 2022-01-25T13:00:17Z https://forum.cannylogic.com/viewtopic.php?pid=959#p959 <![CDATA[Re: CAN Mode, change speed on the fly]]> Nice!!

Is this kind of speed change also possible with LIN?


Thank you

Regards

]]> https://forum.cannylogic.com/profile.php?id=277 2022-01-25T12:45:55Z https://forum.cannylogic.com/viewtopic.php?pid=958#p958 <![CDATA[Re: CAN Mode, change speed on the fly]]> Yes, it is possible to change CAN, or any other driver configuration dynamically for CANNY 7.2 Duo.

]]> https://forum.cannylogic.com/profile.php?id=2 2022-01-24T09:09:47Z https://forum.cannylogic.com/viewtopic.php?pid=955#p955 <![CDATA[CAN Mode, change speed on the fly]]> Hello,

Is it possible to change CAN Speed dynamically? Or is it "hard-coded" as you write diagram in the device?
The purpose is to "scan" different speeds with for example a 8:1 switch until message is correctly received to find the speed of the bus in listen only mode. As a message is correctly received, scanning is stopped.

Thank you

Best regards

Nico

]]> https://forum.cannylogic.com/profile.php?id=277 2022-01-24T08:19:28Z https://forum.cannylogic.com/viewtopic.php?pid=954#p954