1 Topic by nicolas0481

  • nicolas0481
  • Участник
  • Offline
  • Registered: 28-01-2021
  • Posts: 18

Topic: CAN Mode, change speed on the fly

Hello,

Is it possible to change CAN Speed dynamically? Or is it "hard-coded" as you write diagram in the device?
The purpose is to "scan" different speeds with for example a 8:1 switch until message is correctly received to find the speed of the bus in listen only mode. As a message is correctly received, scanning is stopped.

Thank you

Best regards

Nico

2 Reply by Konstantin, CANNY logic

  • Konstantin, CANNY logic
  • Konstantin, CANNY logic
  • Administrator
  • Offline
  • Registered: 19-02-2013
  • Posts: 202

Re: CAN Mode, change speed on the fly

Yes, it is possible to change CAN, or any other driver configuration dynamically for CANNY 7.2 Duo.

Konstantin, CANNY logic's Website

3 Reply by nicolas0481

  • nicolas0481
  • Участник
  • Offline
  • Registered: 28-01-2021
  • Posts: 18

Re: CAN Mode, change speed on the fly

Nice!!

Is this kind of speed change also possible with LIN?


Thank you

Regards

4 Reply by Konstantin, CANNY logic

  • Konstantin, CANNY logic
  • Konstantin, CANNY logic
  • Administrator
  • Offline
  • Registered: 19-02-2013
  • Posts: 202

Re: CAN Mode, change speed on the fly

You can do it too. But unlike CAN it is possible to get false-positive result then you will try to "scan" different LIN speeds this way.

Konstantin, CANNY logic's Website