1 Topic by Fendttech

  • Fendttech
  • Активный участник
  • Offline
  • Registered: 24-05-2024
  • Posts: 28

Topic: can problems on 500 k bus

When i connect my canny duo on a 500 kb bus, then i get strange faults on the bus. On the 250kb bus no errors.
The Bus is the instrument cluster.
The faults are like that some signals not go correct tru the controller.
The diagram in the controller works.

2 Reply by Konstantin, CANNY logic

  • Konstantin, CANNY logic
  • Konstantin, CANNY logic
  • Administrator
  • Offline
  • Registered: 19-02-2013
  • Posts: 201

Re: can problems on 500 k bus

Unfortunately, I can't draw any conclusions from such scant diagnostic data.
According to my data, the controller works fine regardless of the baud rate.
Also, I don't have your setup to reproduce your situation.
Perhaps you should contact someone locally who has CAN diagnostic skills.

Konstantin, CANNY logic's Website