1 Topic by bobbik

  • bobbik
  • Новичок
  • Offline
  • Registered: 12-06-2019
  • Posts: 3

Topic: Yet Another One CanMon problem

I made "vsyo pravilno" like on the wiki, instuction movies etc. I am trying to connect MB W164, found brown/brown red twisted wires, checked with voltometer for H (3,5-4V vs ground) and connected. I am not sure which speed used MB CAN, so tried every option.

     With most of them, there is CANNERR on the right side of status bar, BUT about 100k (95.2 & 100) there's something strange. When connecting usb, there is connection, but then quickly some info blinks on the left of status bar (communication error?)
Then canny led stops to blink and goes green, and message "please connect device" apears on the status bar.
    Any ideas what is going on?

2 Reply by Konstantin, CANNY logic

  • Konstantin, CANNY logic
  • Konstantin, CANNY logic
  • Administrator
  • Offline
  • Registered: 19-02-2013
  • Posts: 202

Re: Yet Another One CanMon problem

Please try 83.3k
Brown/Red - CAN-H
Brown - CAN-L

And please ensure your CANNY and your W164 have strong common GND

Konstantin, CANNY logic's Website

3 Reply by bobbik (edited by bobbik 19-06-2019 10:57:34)

  • bobbik
  • Новичок
  • Offline
  • Registered: 12-06-2019
  • Posts: 3

Re: Yet Another One CanMon problem

i'll check & report tommorow

edit: yesterday i mismatched L and H. Sometimes is good to sleep smile