1 Topic by ukbaggio

  • ukbaggio
  • Новичок
  • Offline
  • Registered: 23-01-2020
  • Posts: 3

Topic: Hi all

Hi all I’m looking for some advice. I’m building a Replica car and I need to send CAN to my dash cluster like indicators warning lights ect.
And I’m looking for a unit to read existing can signals data coming from the BSI
Can you advise me if your units will help.

Thanks.

2 Reply by Konstantin, CANNY logic

  • Konstantin, CANNY logic
  • Konstantin, CANNY logic
  • Administrator
  • Offline
  • Registered: 19-02-2013
  • Posts: 174

Re: Hi all

I'm not sure I understand you correctly.

1. Do you need the tool for explore CAN-bus of your car using PC like this: https://www.youtube.com/watch?v=Dtc4XX374u4 ?
2. Or you need the stand-alone device, for putting in your car, which will accept +12/GND discreet signal, like switches and bulbs, convert is by some rules to CAN-messages and then send it to your dash cluster?
3. Or you need the stand-alone device, for putting in your car, which will receive CAN from BSI, convert by some rules and then send it to another CAN for your dash cluster?

Or you need 1+2 (CANNY 7) ?
Or you need 1+3 (CANNY 7.2 duo) ?

Konstantin, CANNY logic's Website

3 Reply by ukbaggio

  • ukbaggio
  • Новичок
  • Offline
  • Registered: 23-01-2020
  • Posts: 3

Re: Hi all

Hi I’m looking for options 2 and 3.

Thanks.

4 Reply by Konstantin, CANNY logic

  • Konstantin, CANNY logic
  • Konstantin, CANNY logic
  • Administrator
  • Offline
  • Registered: 19-02-2013
  • Posts: 174

Re: Hi all

So CANNY 7.2 duo have 9 GPIOs 12V(24V)/GND + 1 ADC + a couple of CAN interfaces.
I think it can take options 1+2+3 in general case.

Konstantin, CANNY logic's Website

5 Reply by ukbaggio (edited by ukbaggio 25-01-2020 02:50:10)

  • ukbaggio
  • Новичок
  • Offline
  • Registered: 23-01-2020
  • Posts: 3

Re: Hi all

Hi can I use 2x Canny 7 in the same vehicle as I need 18 CAN output
Thanks.

6 Reply by Konstantin, CANNY logic

  • Konstantin, CANNY logic
  • Konstantin, CANNY logic
  • Administrator
  • Offline
  • Registered: 19-02-2013
  • Posts: 174

Re: Hi all

In general, you can use several CAN devices in the single CAN network.

Konstantin, CANNY logic's Website